 |
|
|
|
|
|
|
|
 |
 |
|
|||||
 |
|
||||||
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||
 |
 |
|
|||||||||||||
 |
 |
|
|||||||||||||
 |
 |
|
|||||||||||||
Step 1 |
Select fan location nearest a 12 volt power supply. When prewired by the manufacturer, check proper voltage and fuse. | |
Step 2 |
 |
Remove old fan/vent. |
Step 3 |
 |
Scrape off the old sealant. A clean surface is necessary to provide the best seal with closed cell gasket provided or any other sealants to be used. |
Step 4 |
 |
Prewire power through roof for best installation. |
Step 5 |
 |
Place gasket around flange bottom. |
Step 6 |
 |
Set fan into square opening. |
Step 7 |
 |
Hook 12 Volt
power to fan. Open dome; check air flow direction. |
Step 8 |
 |
Utilize all screw holes for good seal. |
Step 9 |
 |
ASA Compliant Sealant the flange where it meets the roof. |
Step 10 |
 |
ASA Compliant Sealant screw heads. |
Step 11 |
 |
Install interior garnish. Garnish may need to be trimmed. Score with utility knife, cut corners to the score line & break away. Exact sizes are available. When the roof is less than 1” thick, insert a spacer to finish the interior nicely. Spacers are available by calling Fantastic-Vent. |
 |
||
Step 12 |
 |
Looks Great! |
home | products | product registration | operating instructions |
where to buy | about us | f.a.q. | oem catalog
contact us | privacy policy | webmaster
Copyright © 2006 Fantastic Vent. all rights reserved
August 2006